FUTEK IPM52x (D520) Digital Display User Manual

Page 29

"PEAK 1" and "PEAK 2" setup

Programs the functions of the 2 peak capture inputs. Each peak can

be individually programmed.

"TYPE"

Select if peak to be highest or lowest valley

"HI"

High/Peak selection

"Lo" Low/Valley selection

"CHAN 1", "CHAN 2,"CHAN 3” Select channel to do peak on

"SCALE 2" setup

Programs the setup and assignment of the second scale factor. This

would typically be used to switch the display between English and

Metric engineering units. The selection of scale 2 can be activated

from a Front Panel Key (F1 - F4) or a remote input. They must be

programmed to perform the switch to scale 2 under the "SPEC"

branch programming.

"CHAN 1", "CHAN 2"

Select which channel the second scale

factor is being setup for. Both Channel 1 and Channel 2 can be setup

for an individual second scale factor.

"DEC PT" selects decimal point. Push

SELECT key for displaying

decimal point selections and

ENTER key to confirm choice.

"IN Lo" enter in low input value

"DSP Lo" (display low) enter in display value corresponding to low

input value.

"IN HI" enter in high input value.

"DSP HI" (display high) enter in display value corresponding to high

input value.

LOCK OUT CODE SETUP

This enables the program of a lockout code (0 to 50) to limit the

entry into the setup mode. Once a code is entered here, it must be

enter upon trying to enter the setup mode when the meter prompts

for "CODE". Setting the code to 00 disable the lockout code

function.

"CODE" is flashed with the lock out code currently programmed.

Enter in a new code or exit the program (

EXIT key).