FUTEK IPM52x (D520) Digital Display - Manual (Page 26)

25
• "F1 SET" thru "F4 SET" programs the RUN mode function of
the 4 F keys
• "r in 1" thru "r in 2" programs the function of the 2 remote inputs
• "20 Pt" programs the 20 point linearization table and assigns it to
one channel
• "PEAK 1" programs the peak or valley function of each channel
• "PEAK 2" programs second the peak or valley function of each
channel
• "SCALE2" programs the second scaling parameters of each
channel
• "CODE" programs the lockout code for authorized entry into
SETUP
• "DEFAUL" sets meter setup back to default setup
1. "F1 SET", "F2 SET", "F3 SET" and "F4 SET" - RUN MODE function
key setup
This programs the function of the 4 front panel F keys.
A. "ALAR 1" thru "ALAR 4” assigns alarm function to F keys
• Pushing F key displays current alarm set point
• Pushing F key for 4 seconds allows point value to be
changed.
Current set point is displayed with the right most digit
flashing. The set point can now be changed with the
UP and DOWN keys. Select digit to be changed with
SELECT key. Press ENTER key to enter new value
into memory and return to RUN mode
B. "TARE 1", "TARE 2" and "TARE 3" assigns F key for tare
function. 1 for channel 1, 2 is for channel 2 and 3 for math
channel 3.
• Pushing F key will zero the Channel for the input
present.
• Pushing F key for 4 seconds will reset the tare value to
zero.
"CHAN 1" assigns F key to display Channel 1
"CHAN 2" assigns F key to display Channel 2
"CHAN 3" assigns F key to display Channel 3