West Control Solutions KS 42-1 - Manual (Page 23)

Configuration level
Configuration 23 Operating KS4x-1
InP.1
Name Value range Description Default
S.tYP
Sensor type selection 1
0 thermocouple type L (-100...900°C) , Fe-CuNi DIN
1 thermocouple type J (-100...1200°C) , Fe-CuNi
2 thermocouple type K (-100...1350°C), NiCr-Ni
3 thermocouple type N (-100...1300°C), Nicrosil-Nisil
4 thermocouple type S (0...1760°C), PtRh-Pt10%
5 thermocouple type R (0...1760°C), PtRh-Pt13%
20 Pt100 (-200.0 ... 100,0 °C)
21 Pt100 (-200.0 ... 850,0 °C)
22 Pt1000 (-200.0 ... 200.0 °C)
23 special 0...4500 Ohm (pre-defined as KTY11-6)
30 0...20mA / 4...20mA 1
40 0...10V / 2...10V 1
S.Lin
Linearization (only at
S.tYP = 23 (KTY 11-6),
30 (0..20mA) and 40 (0..10V) adjustable)
0
0 none
1 Linearization to specification. Creation of linearization table
withBlueControl (engineering tool) possible. The
characteristic for KTY 11-6 temperature sensors is preset.
Corr
Measured value correction / scaling 0
0 Without scaling
1 Offset correction (at CAL level)
2 2-point correction (at CAL level)
3 Scaling (at PArA level)
fAI1 Forcing INP1 (only visible with BlueControl!) 0
0 No forcing
1 Forcing via serial interface
InP.2
Name Value range Description Default
I.Fnc
Function selection of INP2 1
0 no function (subsequent input data are skipped)
1 heating current input
2 external set-point ( SP.E)
S.tYP
Sensor type selection 31
30 0...20mA / 4...20mA 1
31 0...50mA AC 1
fAI2 Forcing INP2 (only visible with BlueControl!) 0
0 No forcing
1 Forcing via serial interface