KROHNE ALTOFLUX 2W IFM 4042K EN - Manual (Page 43)

Part C Technical data, Block diagram and Measuring principle Section 8
02/2001 ALTOFLUX 2W 43
,I\RXQHHGWRUHWXUQIORZPHWHUVIRUWHVWLQJRUUHSDLUWR.52+1(
Your electromagnetic flowmeter
• has been carefully manufactured and tested by a
company with ISO 9001 certification
• and volumetrically calibrated in one of the world’s
most accurate test rigs.
If installed and operated in accordance with these
operating instructions, your flowmeter will rarely
present any problems. Should you nevertheless
need to return a flowmeter for checkout or repair,
please pay strict attention to the following points:
Due to statutory regulations concerning protection of
the envi-ronment and the health and safety of our
personnel, Krohne may only handle, test and repair
returned flowmeters that have been in contact with
liquids if it is possible to do so with-out risk to
personnel and environment. This means that
Krohne can only service your flowmeter if it is
accompanied by a certificate in line with the following
model confirming that the flowmeter is safe to
handle.
can only service your flowmeter if it is accompanied
by a certificate in line with the following model
confirming that the flowmeter is safe to handle.
If the flowmeter has been operated with toxic,
caustic, flammable or water-endangering liquids, you
are kindly requested
• to check and ensure, if necessary by rinsing or
neutraliz-ing, that all cavities in the flowmeter are
free from such dangerous substances.
(Directions on how you can find out whether the
primary head has to be opened and then flushed
out or neutralized are obtainable from Krohne on
request.)
• to enclose a certificate with the flowmeter
confirming that the flowmeter is safe to handle
and stating the liquid used. Krohne regret that
they cannot service your flowmeter unless
accompanied by such a certificate.
Specimem certificate