KROHNE OPTISONIC 6300 Quickstart EN - Manual (Page 43)

START-UP
3
43
OPTISONIC 6300
www.krohne.com 07/2009 - 7.30959.24.00 - QS OPTISONIC 6300 R04 en
• Go through menu X1...X7 as described in section "Installation menu" in chapter "General
instructions for programming". Correct X5 if needed.
• X9.1: Press enter
• X9.2: Press enter
• X9.3: Press enter
• X9.4: Press enter
• X9.5: Read the preliminary volume flow. Press enter
• X9.6: Check signal
Figure 3-13: Construction (field version)
1 Cover, electronics compartment
2 Cover, terminal compartment for power supply and inputs/outputs
3 Cable entry for power
4 Cable entry for inputs/outputs
5 Cable entry for sensor cable
6 Cover, sensor terminal compartment
INFORMATION!
See also the section "Installation menu" in chapter "General instructions for programming".
CAUTION!
Advice on signal strength:
Advice on signal strength: Advice on signal strength: Advice on signal strength:
Signal > 75%:
Signal > 75%: Signal > 75%: Signal > 75%: good signal, optimization loop not needed
Signal 50...75%:
Signal 50...75%: Signal 50...75%: Signal 50...75%: fairly good signal, optimization loop can improve the signal
Signal 10...50%:
Signal 10...50%: Signal 10...50%: Signal 10...50%: low signal, optimization loop needed
Signal < 10%:
Signal < 10%: Signal < 10%: Signal < 10%: bad or no signal, check settings in menu X6, increase transducer distance and/or
go into the optimization loop.
.book Page 43 Wednesday, August 19, 2009 8:37 AM