KROHNE OPTISONIC 6300 Quickstart EN - Manual (Page 37)

START-UP
3
37
OPTISONIC 6300
www.krohne.com 07/2009 - 7.30959.24.00 - QS OPTISONIC 6300 R04 en
Mounting the DOWN rail in Z-mode Mounting the DOWN rail in Z-mode Mounting the DOWN rail in Z-mode Mounting the DOWN rail in Z-mode
Set transducer positions for both rails according to the table below.
Measure the outer diameter of the pipe with a measuring band.
For Z-mode, you must install the DOWN rail at the opposite location at the pipe. There are two
possible ways to find the exact location:
1. FIND THE LOCATION WITH A FIXED REFERENCE POINT
Calculate the half of the outer diameter. Mark this 180° alignment line on the pipe.
• Mount the DOWN rail in such a way that the transducer is at the marked location.
2. FIND THE LOCATION WITH THE SUPPLIED POSITIONING TOOL
Advised distance [mm] Advised distance [mm] Advised distance [mm] Advised distance [mm] Transducer position [mm] Transducer position [mm] Transducer position [mm] Transducer position [mm]
100...250 -65
>250 0
Figure 3-6: Find the opposite location with a reference point
1 Measure the distance between the transducer of the UP rail and the reference point.
2 Add the Advised Distance and mark the location on the alignment line.
.book Page 37 Wednesday, August 19, 2009 8:37 AM