KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 1.232 (Unit Rev 0 or 1) - Manual (Page 43)

SERIES EL 063010
3-9
TABLE 3-2. REMOTE OPERATION COMMAND SUMMARY
Command Function
CONTROL COMMANDS (Terminate command with ? to display established mode.)
MODE CURRent Enter Constant Current mode
MODE VOLTage Enter Constant Voltage mode
MODE POWer Enter Constant Power mode
MODE RESistance Enter Constant Resistance mode
MODE CONDuctance Enter Constant Conductance mode
MODE SHORt Enter Short mode
MODE OFF Disengage load and enable viewing of Model data.
INPut 1 or INPut ON (alternatively OUT 1) Engage load (load ON)
INPut 0 or INPut OFF (alternatively OUT 0) Disengage load (load OFF)
SET PARAMETER LEVEL COMMANDS (Terminate command with ? to display parameter level.)
CURRent Set Current level in Amperes
VOLTage Set Voltage level in Volts
POWer Set Power level in Watts
RESistance Set Resistance level in Ohms
CONDuctance Set Conductance level in Siemens
MEASUREMENT QUERIES
MEASure:CURRent? Return Load current in Amperes
MEASure:VOLTage? Return Load voltage in Volts
MEASure:POWer? Return Load power in Kilowatts
MEASure:ALL? Return Load Power, Current and Voltage
PROTECTION COMMANDS (Terminate command with ? to display the protection setting for that mode.
Exceeding these user-defined protection levels disengages the UUT and displays fault indication (see
PAR. 3.3.1.)
CURRent:PROTection Set maximum Current level in Amperes
VOLTage:PROTection:OVEr Set maximum Voltage level in volts
VOLTage:PROTection:UNDer Set minimum Voltage level in volts
POWer:PROTection Set maximum load Power in watts
VOLTMETER RANGE COMMANDS (Terminate command with ? to display the range setting. The voltme-
ter range is determined by the lower of: the range setting below and the lowest range that includes the
current VOLT setting.)
SYSTem:RANGe:VOLTage 100V Set Voltage measurement range 0 – 100V
SYSTem:RANGe:VOLTage 200V Set Voltage measurement range 0 – 200V
SYSTem:RANGe:VOLTage 400V Set Voltage measurement range 0 – 400V
SYSTem:RANGe:VOLTage 800V Set Voltage measurement range 0 – 800V
= Numeric Values with or without a decimal point. Examples: 0.0156, 15.6, 156 or 1.56E+3 (scientific
notation: digits with decimal point and exponent).
NOTE: If commands that expect a boolean are entered without an argument, the argument is interpreted as 0.