Figure 2-9. typical master/slave interconnections, Typical master/slave interconnections -12, E 2-9) – KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 1.232 (Unit Rev 0 or 1) User Manual

Page 30

2-12

SERIES EL 063010

FIGURE 2-9. TYPICAL MASTER/SLAVE INTERCONNECTIONS

NOTES:
1 Remove local sense jumpers between Load+ And R+ and between Load–

and R– on Master only. (See Fig. 2-8.)

2. Connect all Electronic Loads to Earth (safety) Ground using ground stud with

wingnut at upper left corner of each rear panel.