KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 1.232 (Unit Rev 0 or 1) - Manual (Page 17)

SERIES EL 063010
1-7/1-8 Blank)
1.10 SAFETY
There no operator serviceable parts inside the case. Service must be referred to authorized per-
sonnel. Using the load in a manner not specified by Kepco, Inc. may impair the protection pro-
vided by the load. Observe all safety precautions noted throughout this manual. Table 1-6 lists
symbols used on the electronic load or in this manual where applicable.
TABLE 1-5. ACCESSORIES
ITEM FUNCTION
KEPCO
PART NUMBER
RJ 22 Master/Slave cable, 1 ft.
(See Note.) Daisy chains Series EL loads with the same voltage for
parallel configurations. 118-1245
Fuse 1.5A, SB Required for units configured to run from 240V a-c
source power. 141-0031
(LittelFuse
31301.5)
Slides Allows the unit to slide out of a rack. 108-0474
Side Support bracket Pair required. Used to provide side support for EL
Load. Requires rear rail at 18-13/16 in. setback. 128-1775
NOTE: For units that use slide mounting, consult Kepco for longer cable lengths.
TABLE 1-6. SAFETY SYMBOLS
SYMBOL MEANING
CAUTION: RISK OF ELECTRIC SHOCK.
CAUTION: REFER TO REFERENCED PROCEDURE.
WARNING INDICATES THE POSSIBILITY OF BODILY INJURY OR DEATH.
CAUTION INDICATES THE POSSIBILITY OF EQUIPMENT DAMAGE.
!