KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.12 (Unit Rev 2) - Manual (Page 79)

SERIES EL 070110
B-19/(B-20 Blank)
B.118 SYSTem:RANGe:VOLTage? QUERY
SYST:RANG:VOLT?
Syntax: Short Form: SYST:RANG:VOLT? Long Form: SYSTem:RANGe:VOLTage?
Returns: = 100V, 200V, 400V or 800V
Description: Indicates full scale voltage range for remote interface voltage readback and VOLTS display on
front panel.
B.119 SYSTem:REPly COMMAND
SYST:REP
Syntax: Short Form: SYST:REP Long Form: SYSTem:REPly
Where = 0 or OFF = replies off or 1 (or ON) = replies ON
Description: Turns reporting of error messages on (1) or off (0). Turns on/off reporting of error messages gen-
erated when SCPI parser analyses SCPI commands. When set to 0, If command is understood, the
EL load provides the normal or expected response. When set to 1, if command is understood, the EL
load provides the normal or expected response, followed by OK. If the command is not understood,
the EL Load responds with “??” and the appropriate error message is added to the error queue. (see
PAR. B.104 for details).
B.120 SYSTem:REPly? QUERY
SYST:REP?
Syntax: Short Form: SYST:REP? Long Form: SYSTem:REPly?
Returns: = 0 or 1
Description: Indicates whether error message reporting is on (1) or off (0).
B.121 SYSTem:SERNumber? QUERY
SYST:SERN?
Syntax: Short Form: SYST:SERN? Long Form: SYSTem:SERNumber?
Returns: where = unit serial number
Description: Returns unit serial number.
B.122 SYSTem:SETTings? QUERY
SYST:SET?
Syntax: Short Form: SYST:SETT? Long Form: SYSTem:SETTings?
Returns: where = system settings (see below).