B.73 [source:]voltage:mode command, B.74 [source:]voltage:mode? query, B.75 [source:]voltage:protection:over command – KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.12 (Unit Rev 2) User Manual

Page 71: B.76 [source:]voltage:protection:over? query, B.72, Source, B.73, B.74, B.75, B.76

SERIES EL 070110

B-11

B.72 [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPlitude]? QUERY

VOLT?

Syntax:

Short Form: [SOUR:]VOLT[:LEV][:IMM][:AMP]?
Long Form: [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPlitude]?
Returns: = voltage setpoint

Description: Indicates voltage setpoint.

B.73 [SOURce:]VOLTage:MODE COMMAND

VOLT:MODE

Syntax:

Short Form: [SOUR:]VOLT:MODE

Long Form: [SOURce:]VOLTage:MODE

Description: Selects voltage mode.

B.74 [SOURce:]VOLTage:MODE? QUERY

VOLT:MODE?

Syntax:

Short Form: [SOUR:]VOLT:MODE?

Long Form: [SOURce:]VOLTage:MODE?

Returns: = CURR, POW, VOLT, RES, COND, OFF

Description: Returns the present mode: CURRent, POWer, VOLTage, RESistance, CONDuctance, OFF

B.75 [SOURce:]VOLTage:PROTection:OVEr COMMAND

VOLT:PROT:OVE

Syntax:

Short Form: [SOUR:]VOLT:PROT:OVE
Long Form: [SOURce:]VOLTage:PROTection:OVEr
where = overvoltage protection limit

Description: Sets overvoltage protection limit. Overvoltage protection setpoint is stored in non-volatile memory;

value is restored upon power-up.

B.76 [SOURce:]VOLTage:PROTection:OVEr? QUERY

VOLT:PROT:OVE?

Syntax:

Short Form: [SOUR:]VOLT:PROT:OVE?
Long Form: [SOURce:]VOLTage:PROTection:OVEr?
Returns = overvoltage protection limit

Description: Indicates overvoltage protection limit.

B.77 [SOURce:]VOLTage:PROTection:OVEr:STATe[:LEVel] COMMAND

VOLT:PROT:OVE:STAT

Syntax:

Short Form: [SOUR:]VOLT:PROT:OVE:STAT[:LEV]
Long Form: [SOURce:]VOLTage:PROTection:OVEr:STATe[:LEVel]
where = 1 (enabled) or 0 (disabled)

Description: Enables (1) or disables (0) the overvoltage protection level set using VOLT:PROT:OVE. This

command saves having to change the protection level to some value outside of the operating range.

B.78 [SOURce:]VOLTage:PROTection:OVEr:STATe[:LEVel]? COMMAND

VOLT:PROT:OVE:STAT?

Syntax:

Short Form: [SOUR:]VOLT:PROT:OVE:STAT[:LEV]
Long Form: [SOURce:]VOLTage:PROTection:OVEr:STATe[:LEVel]
where = 1 (enabled) or 0 (disabled)

Description: Indicates whether the overvoltage protection level set using VOLT:PROT:OVE is enabled (1) or

disabled (0).