beautypg.com

GW Instek GOS-6200 User Manual

Page 20

background image

GOS-6200 OSCILLOSCOPE

USER MANUAL

⎯ 34 ⎯

(39)EXT—This BNC socket is the external trigger signal input.

In dual X-Y mode, signals at this input are used for the X deflection.

Pressing the TRIG. SOURCE (29) pushbutton until the information of

“EXT, slope, coupling” is shown up in the readout and the TRIG.

SOURCE “EXT or E/10” LED is lighted, switches the input on.

The outer (ground) connection is galvanically connected to the

instrument ground and consequently to the safety earth contact of the

line/mains plug.

The maximum input voltages of the instrument input terminals and probe

input terminals are listed in the section of 3-6. “Withstanding voltage of

Input terminals”. Do not apply voltage higher than the limit.

4-2.Rear Panel

The rear panel provides input power and additional signal connections.

GOS-6200 OSCILLOSCOPE

USER MANUAL

⎯ 35 ⎯

(40)Line voltage selector and input fuse holder—Select power source

and contain the primary power fuse

The fuse rating is shown in the section of 3-2 Checking the line

voltage.

(41)AC power input connector

Connect the AC power cord to the power supply of instrument, the

power cord protective-ground connection is connected to the exposed

metal part of the instrument. The power cord must be connected to a

proper grounded source for electrical-shock protection.

(42)TRIGGER SIGNAL Output—BNC socket

The signal selected by the TRIG. SOURCE (29) is available. This

output may be used to connect to a frequency counter or other

instrument.

(43)Z-Axis Input—BNC socket

Connect external signals to the Z-axis amplifier for intensity

modulating the CRT display. This terminal is DC-coupled. The

intensity is lowered by a positive signal, while it is increased by a

negative signal.