GW Instek GFG-3015 - Manual (Page 45)

GFG-3015 p.41
Abbreviating Commands
Most commands have both long form and short form. The list for each command
in this section shows the abbreviations in upper case. For instance, you can
enter the query
:SOURce:TRIGger:STATe ?
simply as:
:SOUR:TRIG:STAT ?
6.22 The Commands of RS-232 Serial Interface
Common commands
Command Function Parameter Arguments
*CLS Clear status command None
*IDN? Identification query None
*RCL Recall command <0~9>
*SAV Save command <0-9>
*RST Default setting
Commands of the instrument
Command Function Parameter Arguments
:SYSTem:ERR ? Check the type of error
messages None
:FUNCtion:WAVeform Set the waveform of main
frequency <1>Sinusoid
<2>Triangle
<3>Square
:FUNCtion:WAVeform ? Check the present waveform
of main frequency None
:FREQuency Set the main frequency Numeric data
:FREQeency ? Check the main frequency None
:AMPLitude:VOLTage Set the value of output
amplitude Numeric data
:AMPLitude:VOLTage ? Check the value of output
amplitude None
:AMPLitude:UNIT Set the unit of amplitude <1>Vpp
<2>Vrms
<3>dBm
:AMPLitude:UNIT ? Check the unit of amplitude None
:OFFSet Set the voltage of offset Numeric data
:OFFSet ? Check the voltage of offset None
:DUTY Set the value of duty Numeric data
:DUTY ? Check the value of duty None
:SOURce:WAVeform Set the waveform of
modulation mode <1>Sinusoid
<2>Triangle
<3>Square