GW Instek GFG-3015 - Manual (Page 27)

GFG-3015 p.23
Hz/Vpp
KHz/Vrm s
KHz/Vrm s
DEG/%
Hz/Vpp
KHz/Vrm s
KHz/Vrm s
DEG/%
Hz/Vpp
Hz/Vpp
LOG S
LIN S
INT/EXT
RATE
STOP
START
SWP CF
SYM
STOP
START
LOG S
LIN S
INT/EXT
RATE
STOP
START
SWP CF
SYM
STOP
START
Procedure:
Press to select SINE wave for main output.
Press in sequence.
Then press to select linear sweep mode.
Press in sequence.
Press in sequence.
Press in sequence.
Press in sequence.
Press
The Modulation/Sweep Output BNC will output 1Hz Triangle wave.
In addition, you can use and the Rotate Knob to modify the
value you need.
Example of the Setup of LOG Sweep
To set the following conditions:
Output function: Triangle Wave. Start frequency: 10kHz.
Output amplitude: 10Vpp. Stop frequency: 100kHz.
Sweep mode: LOG. Sweep signal symmetry: 90%.
Speed: 0.1 second.
Procedure:
Press to select TRIANGLE wave for main output.
Press in sequence.
Then press to select LOG sweep mode.
Press in sequence.
Press in sequence.
Press in sequence.
Press in sequence.
AMPL
1
1
SHIFT 1 0
5 0
MOD/ON
FUNC
1
1
SHIFT 1 0
9 0
SHIFT
0
0
0
◄ ►
FUNC
1 0
AMPL 1 0