GW Instek GSP-930 Quick start guide - Manual (Page 32)

GSP-930 Quick Start Guide
30
6. The spectrum analyzer will automatically find
the firmware on the USB flash drive and start
to update the firmware. When finished, the
message “Upgrade is finished” will be shown
at the bottom of the screen followed by
“Rebooting”.
Rebooting
7. The system will automatically restart after the
rebooting message.
Note
The upgrade process may take a few minutes.
Restoring Default Settings
Description The factory default settings or user-defined
presets can be easily restored using the Preset
key on the front panel. By default, the factory
default settings are restored with the Preset
key.
For details on how to configure the preset
settings, please see the user manual.
Steps 1. Press
Preset
.
2. The spectrum analyzer will load the preset
settings.