Edwards Signaling 108-DN Series - Manual (Page 8)

P/N 3100179 ISSUE 1 PAGE 8
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
BAUD RATE - 125 Kbps 0 0
BAUD RATE - 250 Kbps 0 1
BAUD RATE - 500 Kbps 1 0
BAUD RATE - 125 Kbps 1 1
MAC ID 0 0 0 0 0 0 0
MAC ID 1 0 0 0 0 0 1
MAC ID 2 0 0 0 0 1 0
MAC ID 3 0 0 0 0 1 1
MAC ID 4 0 0 0 1 0 0
MAC ID 5 0 0 0 1 0 1
MAC ID 6 0 0 0 1 1 0
MAC ID 7 0 0 0 1 1 1
MAC ID 8 0 0 1 0 0 0
MAC ID 9 0 0 1 0 0 1
MAC ID 10 (0x0A) 0 0 1 0 1 0
MAC ID 11 (0x0B) 0 0 1 0 1 1
MAC ID 12 (0x0C) 0 0 1 1 0 0
MAC ID 13 (0x0D) 0 0 1 1 0 1
MAC ID 14 (0x0E) 0 0 1 1 1 0
MAC ID 15 (0x0F) 0 0 1 1 1 1
MAC ID 16 (0x10) 0 1 0 0 0 0
MAC ID 17 (0x11) 0 1 0 0 0 1
MAC ID 18 (0x12) 0 1 0 0 1 0
MAC ID 19 (0x13) 0 1 0 0 1 1
MAC ID 20 (0x14) 0 1 0 1 0 0
MAC ID 21 (0x15) 0 1 0 1 0 1
MAC ID 22 (0x16) 0 1 0 1 1 0
MAC ID 23 (0x17) 0 1 0 1 1 1
MAC ID 24 (0x18) 0 1 1 0 0 0
MAC ID 25 (0x19) 0 1 1 0 0 1
MAC ID 26 (0x1A) 0 1 1 0 1 0
MAC ID 27 (0x1B) 0 1 1 0 1 1
MAC ID 28 (0x1C) 0 1 1 1 0 0
MAC ID 29 (0x1D) 0 1 1 1 0 1
MAC ID 30 (0x1E) 0 1 1 1 1 0
Pin 1 (+) + 24V DC Red Wire
Pin 2 (-) - 24V DC Black Wire
2.A two (2) position screw terminal is provided to connect separate 24V DC light source operating power to the
Chameleon DeviceNet Status Indicator. The terminals for the 24V DC unit are labeled as "+" and "-". Make
connections as follows:
3.If it is desired to power the light sources from DeviceNet power, jumper (V+) and (V-) on the 5 position DeviceNet
terminal block to (+) and (-) respectively on the 2 position screw terminal.
Set DIPSWITCH S1 for the BAUD RATE and MAC ID required as follows:
Note the legend on the dipswitch for the sense of 0 and 1 (0 = OFF and 1 = ON)