Triton FT5000 PC-BASED ATM Installation Manual - Manual (Page 45)

45
NMD-100 D
ISPENSING
M
ECHANISM
R
EMOVAL
/I
NSTALLATION
5. Turn the dispenser power switch located just to the right of the power
connector to OFF (0) (Figure 4).
6. Refer to Figures 4 and 5. Disconnect the DC power , serial communications,
and shutter cables from the dispensing mechanism. Remove the cables
from the cable clips attached to sides of dispenser.
Figure 4. Remove AC power cable.
Figure 5. Remove shutter and serial
cables (left side of dispenser).
7. Using two persons, grasp the
green handles and lift the dis-
penser off the rails and slide out
of the cabinet (Figure 6). Place the
dispenser in a safe location where
it will not get accidently damaged.
Figure 6. Lift dispenser off rails and
guide out of cabinet. Use 2-person lift!
AC power cable
On/Off switch
8.* If installing the cabinet at this
time, follow the procedures pro-
vided in “Site Preparation” sec-
tion of this manual.
Serial cable
Shutter
cable
***WARNING***
Two persons recommended to remove the dispenser from the cabinet. When
removing dispenser from cabinet, use caution not to damage the throat
extension on front of dispenser mechanism.