Triton FT5000 PC-BASED ATM Installation Manual - Manual (Page 10)

10
ATM I
NSTALLATION FOR
A
CCESSIBILITY
1. This document supersedes all other
information provided by Triton for
ATM installation for accessibility.
2. Information provided in this
manual is based on federal guide-
lines (ADA Accessibility Guidelines
for Buildings and Facilities –
ADAAG) as amended through
January 1998. You should verify it
has not been amended. States may
also have accessibility codes.
These codes may be more restric-
tive than the federal guidelines.
Please verify this with the state
where the ATM is to be installed
prior to installation. For state con-
tact information, you may call the
ADA information line at 1-800-514-
0301.
3. For countries other than the US,
please use the guidelines for ac-
cessibility for that country.
4. A complete copy of the ADAAG
referred to here can be found at
http://www.access-board.gov. In-
cluded in this document is the sec-
tion of the ADAAG specifically for
ATMs. For additional information
on floor surfaces and other
ADAAG requirements, please see
the complete specification.
4.34 Automated Teller
Machines.
4.34.1 General. Each machine re-
quired to be accessible by 4.1.3
(Accessible Buildings: New Con-
struction) shall be on an accessible
route and shall comply with 4.34
(Automated Teller Machines).
4.34.2 Clear Floor Space. The auto-
mated teller machine shall be lo-
cated so that clear floor space com-
plying with 4.2.4 (Clear Floor or
Ground Space for Wheelchairs)
is provided to allow a person using
a wheelchair to make a forward ap-
proach, a parallel approach, or both
to the machine.
4.34.3 Reach Ranges.
(1) Forward Approach Only. If only a
forward approach is possible, operable
parts of all controls shall be placed within
the forward reach range specified in
4.2.5 (Forward Reach).
(2) Parallel Approach Only. If only a
parallel approach is possible, operable
parts of controls shall be placed as fol-
lows:
(a) Reach Depth Not More Than 10
inches (255 mm). Where the reach
depth to the operable parts of all con-
trols as measured from the vertical plane
perpendicular to the edge of the unob-
structed clear floor space at the farthest
protrusion of the automated teller ma-
chine or surround is not more than 10
inches (255 mm), the maximum height
above the finished floor or grade shall
be 54 inches (1370 mm).
FT5000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE