Triton FT5000 PC-BASED ATM Installation Manual User Manual
Page 27
27
I
NSTALLING
C
ABINET
T
HROUGH
W
ALL
O
PENING
1. Carefully inspect the unit for any
shipping damage and report any
damage immediately to the
shipping company. Refer to the
warranty information in the user or
service manual (as applicable) for
information about reporting
shipping damage.
2. After unpacking the unit, remove
the dispensing mechanism
following the procedures in the
section “NMD-100 Dispensing
M e c h a n i s m : R e m o v a l /
Installation” found on pages 44-
47. After removal of the dispenser,
move the cabinet using the proper
lifting/moving device towards the
wall opening.
3. Slide the unit up to the opening
until the sleeve portion of the
cabinet is near the wall (Figure 2).
4. Measure the distance from the
bottom of the wall opening to the
bottom of the sleeve. This will be
the height requirement of the
“plinth”, if needed. Add an
additional 1/8” (3.175mm) to your
measurement for clearance (Figure
3).
Figure 3. Measure from bottom of
wall opening to bottom of sleeve.
S
ITE
P
REPARATION
/I
NSTALLATION
Note
DO NOT install the control
panel trim at this time.
Figure 2. Slide unit up to interior
wall.
Figure 1. Ensure power supply is in
the OFF (0) position.
* Important*
Open the control panel sleeve door .
Verify that the power switch located
on the unit power supply is in the OFF
(0) position. See Figure 1.
* See Note next page for additional
measurement.