Triton FT5000 PC-BASED ATM Installation Manual - Manual (Page 28)

28
FT5000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
Figure 5. Mount cabinet on plinth.
Sleeve
5. If no plinth is needed, slide the unit forward towards the wall opening so the
sleeve protrudes slightly out the front exterior (Figure 4). This is needed to
temporarily affix the control panel trim. Minor adjustments for raising the
unit can be made using the cabinet leveling feet (See “Adjusting Height of
Unit” page 30).
6. If a plinth is used (either built or purchased), mount the cabinet on the plinth
Figure 5). The optional plinths have a wall tab that is aligned facing the outside
exterior wall. Anchor the cabinet to the plinth using the bolts provided (optional
plinth) or secure to your built plinth. Tighten bolts enough to secure the two
together for moving the unit.
7. Slide/move the unit forward towards the wall opening so the sleeve protrudes
slightly out the front exterior (Figure 4). This is needed to temporarily affix
the control panel trim. Minor adjustments for raising the unit can be made
using the plinths leveling feet (See “Adjusting Height of Unit” page 30).
Figure 4. Sleeve protrudes slightly.
8. Locate the control panel trim included with the unit accessories. On the back
side are 4 clips (Figure 6a) that will align with 4 slots on the control panel (Figure
6b).
**Caution**
When placing the unit on the plinth, be careful not to damage the
front of the sleeve as this has the control panel electronics and
hardware mounted.
Note
Before installing the plinth, adjust the leveling feet a 1/4" (6mm) below the
platform to gain access with an open-end box wrench for additional
adjustments.