Triton FT5000 PC-BASED ATM Installation Manual - Manual (Page 34)

34
FT5000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
S
EALING THE
C
ONTROL
P
ANEL
T
RIM
To ensure that the temperature around the unit is maintained during cold weather,
it’s important that the wall opening is prepared correctly . Any cavity in the wall
should be sealed to provide a flush surface. The gap between the ATM and the
inside wall opening should be left clear to allow air to circulate at room temperature.
After the control panel trim is installed, a good weather seal is needed between the
exterior wall and the trim. A suitable water -resistant sealant product is required
around the periphery of the control panel trim. There are also products that are color
tinted to closely match the trim color.
Drain hole location
**IMPORTANT**
SEAL THE TRIM TO THE EXTERIOR WALL WITH A
WATER-RESISTANT SEALANT TO PREVENT WATER
INTRUSION. DO NOT SEAL AROUND THE BOTTOM
OF THE TRIM! A SMALL DRAIN HOLE IS LOCATED
ON THE UNDERSIDE THAT MUST BE CLEAR.
Figure 15. Control panel trim sealed.