Triton FT5000 PC-BASED ATM Installation Manual - Manual (Page 30)

30
FT5000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
Adjusting Height of Unit
Triton Systems offers two (2) metal-constructed optional plinths w/leveling
feet. The plinths come in 2 heights: 2 - 3/8" (61 mm) and 4 - 3/4" (122 mm).
Based on the height requirement needed, you can either:
1) Raise the unit with the leveling feet installed in the cabinet (Business
Hours and Level 1) using a 1/4" (6mm) nut driver/socket.
Caution: The leveling feet are primarily for that purpose - leveling the
ATM,
not to raise the unit by more than 3/4".
2) Construct your own. A “plinth” is a platform on which the ATM rests or
is secured. A plinth enables the ATM to be installed at the required height
through the wall. If built, it must be no smaller than the base of the cabinet
and must be constructed of a material that is capable of supporting the
weight of the ATM.
3) Purchase an optional plinth (Figure below). Raise the unit by a fixed
amount (2 - 3/8" or 4 - 3/4") and, if needed, adjust up using the plinths
leveling feet (see Note below).
Caution: Leveling feet are primarily used for that purpose - leveling the
ATM, not to raise the unit by more than 3/4".
4) “Stack” the optional plinths. Before securing two (2) plinths together ,
remove the leveling feet from the top plinth.
c c c c c Anchor hole
d d d d d Leveling foot
e e e e e Cabinet hole
Note
Before installing the plinth, adjust the leveling
feet a 1/4" (6mm) below the platform to gain
access with an open-end box wrench for
additional adjustments.