Seed Hawk AIRCART 2012 - Manual (Page 50)

Seed Hawk
®
Manual Aircart Page 45
15. Refer to Section 7.3.1.5 to configure the settings of each of the sensors
installed on your system. This step does not perform any calibrations on your
sensors.
16. Refer to Section 7.3.2 to set your implement width.
17. Refer to Section 7.3.4 to calibrate your Ground Speed Sensor.
18. Refer to Section 7.3.5 to calibrate each of the meters installed on your
system.
19. System is ready for use.
7.3.1.3 ADD A SENSOR
To add a sensor, simply highlight the
sensor you would like to install.
NOTE
7.3.1.4
: The sensor that you are trying
to install should read “None”.
If the highlighted sensor
shows OK prior to install,
there is already a sensor
installed in this position. If this
is the case, please see section
.
Go out on the implement and physically plug in the sensor.
Return to the Monitor. Press Install.
If the display shows “OK” next to the
sensor, the sensor has been
successfully installed.