Seed Hawk AIRCART 2012 - Manual (Page 21)

Seed Hawk
®
Manual Aircart Page 16
4.1.3 Pairing the Remote
The remote should arrive ready for the customer to use, but if it becomes
unpaired from the receiver or a replacement remote is purchased, it is necessary
to register the remote with the receiver.
1. Switch OFF or DISCONNECT the
power to the receiver.
2. Switch ON or reconnect the
power to the receiver. This opens
a 20 second registration window in
the receiver. If you are looking at the
receiver circuit board, the fault LED
flashes.
3. Immediately PRESS and HOLD the
transmitter green button for a
minimum of 10 seconds during this
20 second window. When the
Transmitter is registered the fault
LED goes out, and the set LED
comes on.
4. The transmitter can now
communicate with the receiver, and
a light on the receiver flashes with
each button press on the transmitter.