Seed Hawk AIRCART 2012 - Manual (Page 30)

Seed Hawk
®
Manual Aircart Page 25
4.3.4 Conveyor Transport Position
NOTE: Fill conveyor should
always be secured for transport,
no matter how short the distance.
Clean out conveyor prior to
transport or storage.
1. Latch down the conveyor hopper
then fold it up on top of the
conveyor tube. Be sure to secure
it with the tie down strap supplied.
2. Arrange the conveyor so that the
upper rest is positioned on the
conveyor saddle at the front of
the aircart, Figure 20.
3. Raise the locking mechanism at
the rear of the aircart, Figure 21.
The handle can be unlocked and
swung towards the aircart for
transport.
4. Ensure to place pin back into
locking mechanism so that it
cannot disengage during
transportation,
Figure 22.
5. Push conveyor diverter valve
back to the fan position. Move
hydraulics in both directions to
relieve pressure. This is most
important for the tilt cylinder so
that it is not applying
unnecessary force on the support
arms.
6. Secure
outer arm locking
mechanism, Figure 23. Again
ensure to replace pin so that lock
does not disengage during
transportation.
Figure 20
Figure 21
Figure 22
Figure 23