LumaSense Technologies INNOVA 1412i - Manual (Page 23)

Chapter 2
______________________________________________________________________
_____________________________________________________________________________
BE6025-15 1412i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 23 of 202
Fig.2.1 The 1412i gas monitor homepage
2.6 Setting-up user Levels
Press the Lock function push button on the front of the Monitor.
This enables setting up 3 different user levels, Level 1, Level 2 and
Level 3.
These user levels are password protected.
Level 1 is the Operator level, which enables start/stop and reading of
measurement results. Partial Reset is possible.
Level 2 is the Expert level, which in addition to Level 1 access
enables set up of parameters. Full Reset is possible.
Level 3 is the Super-User level, which allows all possible operations
including calibration.
2.6.1 Default settings for User Level and Password.
Before dispatched from the factory the User Level and the Password
are set to the following default setting.
User Level 3
And the default setting for the Password is: