LumaSense Technologies INNOVA 1412i - Manual (Page 20)

Chapter 2
______________________________________________________________________
_____________________________________________________________________________
BE6025-15 1412i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 20 of 202
below step 6 as the IP address is set by the DHCP server. If you
want yourself to set the IP address of the 1412i press the S1 (No)
key. The screen display now shows the following text.
4. Here you can change the IP address of the 1412i gas monitor in
case the IP address is not set by a DHCP server in the local
network. If you want to change the IP address, press the
¿ key. If
the IP address does not need to be changed, press the ▼ key and
you will proceed to the below step 6.
If you selected to change the IP address, the screen display now
shows the following text.
5. Here you can change the 4 individual numbers in the IP address
by using the ▲ and ▼ keys. Each of the 4 individual numbers can
be set in the range from 000 to 255.
You can step between the 4 individual numbers in the IP address
by using the ◄ and ► keys.
In case you want to return to the start value of the IP address
press the S1 (CANCEL) key. In case you want to return to the
default stored value of the IP address press the S3 (DEFAULT)
key.
When you have set the IP address, press the
¿ key. The screen
display now shows the following text.
6. Here you can set the IP port number for the Ethernet
communication. This normally does not need to be changed. If
you want to change the IP port number press the
¿ key. If the IP
port numbers does not need to be changed, press the ▼ key and
you will proceed to the below step 8. If you selected to change the
IP port number the screen display now shows the following text.
1412i'S IP ADDRESS 192.168.000.200
PRESS ENTER TO CHANGE VALUE
1412i'S IP ADDRESS 192.168.000.200
CANCEL DEFAULT
1412i'S IP PORT NUMBER: 23
PRESS ENTER TO CHANGE VALUE
1412i'S IP PORT NUMBER: 23
CANCEL DEFAULT