LumaSense Technologies INNOVA 1412i - Manual (Page 151)

Chapter 12
______________________________________________________________________
_____________________________________________________________________________
BE6025-15 1412i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 151 of 202
12.5.1 Retaining Existing Calibration Factors
When zero-point, humidity-interference and cross-interference
calibrations are performed, all the installed filters are calibrated. In
some case, you may wish to keep the calibration factors already
present in your monitor. If this is the case, use the following
instructions.
Fig.12.8 Schematic diagram showing the calibration task Set-Up
Tree (general)