Hired-Hand System 1000 Power Curtain Eight Stage Controller - Manual (Page 15)

System 1000™ Power Curtain™ Controller 12
Now scroll through the features using the Select Features up or down arrow keys to
make sure you have hidden all features you desire. When finished, press Target
Temperature Up to return to Automatic Mode.
12. Initializing the Controller
Initializing the controller means returning the controllers programming to the original
factory settings. If you are having trouble with the controller and think it might be in the
programming, you can re initialize the controller by following this procedure.
Select
Feature
Change
Setting
Program Features
0 Cut power to the unit.
1 Re-apply power to the unit.
2 While the controller is starting up, the controller will darken all segments of the
screen. (The screen will look like several black squares.) When this happens, press
and hold down the Change Setting up key with the Select Feature down key. Keep
holding both keys until the word "Init." appears, then release.
3 The controller will then be re-initialized and ready to operate in a few seconds.
4 IMPORTANT!! Always "Zero out" the controller after initializing to ensure that
the power unit counters are accurate. If the counters are not reading the right
position, it could cause improper operation. To Zero out the controller, press
manual close and let the curtain fully close. The controller will stop motion when
the curtain is closed. The controller will pause for about seven seconds while
resetting.
5 You will need to reprogram the controller now, making sure that all questions are
answered accurately.