Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 11-05 - Manual (Page 21)

Part No. 4801-5138 Rev 11-05 Rollup Curtain System Page 21
9. Rack & Pinion Rollup Drive Options
9.1 Horizontal Drive Option
1. Install pinion assembly (6419-0100) to rack (0404-4520) as shown in
Fig. 13. Run pinion assembly about half way down rack as shown.
2. Repeat for second pinion assembly (6419-0100) and rack (0404-
4520). NOTE: Make sure that both pinion assemblies are the same
distance from top of racks.
3. Attach gear pinion adapter (0404-5144) to the pinion assembly
(6419-0100).
4. Repeat for second pinion assembly. Use 1/4-20 x 1-1/2 HEX screws
(1004-7075) and 1/4-20 lock nuts (1001-1446) to attach pinion
adapters to pinion assembly.
5. Install Rollup drive assembly to each end of motor/gear box. Fasten
gear pinion adapters (0404-5144) to each end of motor shaft with
3/8-16 screws (1004-1426) & nuts (1001-1457) provided
6. Attach the Rollup Drive Gear Bracket (0404-5142) to the motor with
1/4-20 HEX screws (1001-7074).
7. Attach the Rollup Drive Gear Bracket (0404-5142) to the bottoms of
the pinion assemblies with 1/4-20 HEX screws (1001-7075) and nuts
(1001-1446) provided.
8. Go to Section 13 to attach the Rollup Drive Rack Mounts (0404-
5141) to the top and bottom of the racks.
1004-1423
Screw 3/8x16x2
Motor/Gear Box
Assembly
1004-1423
Screw 3/8x16x2
1001-1457
Lock Nut 3/8x16
6419-0104
Rollup Pinion
Assembly-Left
0404-5142
Gear Bracket
1004-1426
Screw 3/8x16x1
Fig. 13
0404-5144
Pinion Adaptor
1004-1446
Lock Nut
1/4x20
1004-7075
Screw 1/4x20x11/2
1001-1457
Lock Nut
3/8x16
6419-0100
Rollup Pinion
Assembly-Right Rack
Rack
Rack
4' - 6450-5421
5' - 6450-5420
10' - 6450-5427
Motor Drive-Horizontal
Assembled