Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 84)

74 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Power supply specifications
6
DRAFT: BROCADE CONFIDENTIAL
Power cords
All Brocade devices ship with US-compatible power cords unless otherwise specified at the time of
order. United Kingdom- and European-compatible power cords are also available.
For power cord specifications, refer to “Input connector and plug” on page 77
Warranty
FastIron GS and GS-STK switches come with a 5-year limited lifetime warranty. The software comes
with a 90-day warranty.
Power supply specifications
This section contains the following information for the power supplies that ship with FGS and
FGS-STK devices.
Overview
Each FGS or FGS-STK switch comes with one alternating-current (AC) or direct-current (DC) power
supply, depending on how it was ordered from the factory. All models have two power supply slots,
enabling you to install a second power supply for redundancy (if applicable) or for more POE power.
DC supplies are available for some devices, in which you can use any combination of AC and DC
supplies in the same device. The following power supplies may be installed in your FGS switch:
• RPS-FGS (AC power supply)
10GBase-ER SMF LC connector for XFP
module 9 1550 nm up to 40000 (40
km)
10GBase-LR SMF LC connector for XFP
module 9 1310 nm 2 – 10000
(10km)
10GBase-SR MMF LC connector for XFP
module 62.5/125 160 2 – 26
MMF 62.5/125 200 2 – 33
MMF 50/125 400 2 – 66
MMF 50/125 500 2 – 82
MMF 50/125 2000 2 – 300
10GBase-ZR SMF LC connector for XFP
module 9 1550 nm up to 80000 (80
km)
10GBase-ZRD SMF LC connector for XFP
module 9 1530.33 – 1561.42
nm up to 80000 (80
km)
TABLE 18 Cable Length Summary (Continued)
Cable Type Connector Type Core Diameter
(microns) Modal Bandwidth
(MHz*km) or Wavelength
(nm) Range (meters)