Brocade ICX 6430-C Compact Switch Hardware Installation Guide - Manual (Page 42)

Changing the temperature warning level
To change the temperature at which the device sends a warning message, enter a command similar to
the following at the Privileged EXEC level of the CLI.
device# temperature warning 83
Syntax: temperature warning value
The value variable is the temperature warning level, in Celsius. You cannot set this level higher than
83°C . The temperature warning level must be at least 5 degrees Celsius less than the temperature
shut down level, which is automatically set by the device.
The following console and syslog message is displayed when the temperature reaches the warning
level:
!!! Temperature is over warning level on stack unit 1!!!
Temperature shutdown levels
When the temperature crosses the critical (shutdown) threshold levels, the device will reset after 5
minutes. The following console and syslog message is displayed:
!!! Temperature is over shutdown level, please shutdown your stack unit 1 to avoid
hw damage!!!
NOTE
Brocade recommends that you shut down your stack unit to avoid any hardware damage.
Changing the temperature warning level
40 Brocade ICX 6430-C Compact Switch Hardware Installation Guide
53-1003080-01