Brocade ICX 6430-C Compact Switch Hardware Installation Guide - Manual (Page 12)

• Console management interface (RJ45 serial port)
• Out-of-band management interface (RJ45 port)
• Reset button
1 Console port
2 Slot 1 (10/100/1000 Mbps ports)
3 Slot 2 (Copper uplink ports)
4 Slot 3 (SFP uplink ports)
5 Out-of-band management port
6 Reset button
FIGURE 3 Management interfaces on an ICX 6430-C12 device
Console management interface
The console management interface is an RJ45 serial port that allows you to configure and manage the
device using a third-party terminal emulation application from a directly connected PC.
Out-of-band management interface
The out-of-band management interface is an RJ45 port that allows you to configure and manage the
device from the network.
Reset button
The reset button allows you to restart the system without switching the power supplies off and on or
using the CLI. When the reset button is pressed, the system resets and the software is reloaded. The
button is directly below the power LED on the very left of the device’s front panel.
Network interfaces for a ICX 6430 device device
An ICX 6430-C device contains the following interfaces:
• 12 1GbE ports with RJ45 copper connectors (Slot 1, Ports 1- 12)
‐ Ports 1- 4 are dedicated PoE/PoE+ ports.
Standard 802.3at PoE+ ports support up to 30W per port.
Standard 802.3af PoE ports support up to 15.4W per port.
Total PoE power capacity is 68W.
Some possible PoE/PoE+ configuration combinations include:
‐ 2 standard PoE ports supporting full capacity (15.4W x 2 = 30.8W)
Console management interface
10 Brocade ICX 6430-C Compact Switch Hardware Installation Guide
53-1003080-01