Brocade ICX 6430-C Compact Switch Hardware Installation Guide - Manual (Page 26)

1. Use tape to place the Wall Mount Holes Location template against the wall, in the same position
that you plan to place the device against the wall. The Wall Mount Holes Location template serves
as a guide to drilling the screws and mount anchors into the correct location on the wall in order to
place the device in the desired location.
2. Using the Wall Mount Holes Location template as a guide, drill two holes in the wall where you
want to mount the device.
3. Hammer the wall mount anchors into the two holes.
4. Use the #2 Phillips screwdriver to secure the two wall mount screws into the wall mount anchors.
Leave a gap of 4.0 to 4.5 mm between the screw head and the wall.
FIGURE 10 Preparing to wall mount the device
1. Drilled holes in wall
2. Wall mount anchors
ICX6430-C Installation
24 Brocade ICX 6430-C Compact Switch Hardware Installation Guide
53-1003080-01