Slot designations, 1gbe rj45 ports, 100/1gbe uplink ports – Brocade ICX 6430-C Compact Switch Hardware Installation Guide User Manual
Page 13

1 standard PoE+port supporting full capacity (30W)
1 PoE or PoE+ port supporting partial capacity, no greater than 7W (7W)
Total PoE/PoE+ power: 67.8W
‐
2 standard PoE+ ports supporting full capacity (30W x 2 = 60W)
1 PoE or PoE+ port supporting partial capacity, no greater than 7W (7W)
Total PoE/PoE+ power: 67W
‐
4 standard PoE ports supporting full capacity (15.4W x 4 = 62W)
Total PoE power: 62W
•
4 100/1GbE uplink ports:
‐
2 100/1GbE RJ45 uplink ports (Slot 2, ports C1-C2)
‐
2 100/1GbE SFP uplink ports (Slot 3, ports F1-F2)
Slot designations
Network and management interfaces
on page 9 for the location of slots 1- 3 on the front panel
of an ICX 6430-C device.
Slot designations for a ICX 6430-C device
TABLE 1
Device
Slot 1 (1GbE RJ45 ports)
Slot 2 (100/1GbE RJ45 ports)
Slot 3 (100/1GbE SFP ports)
ICX 6430-C12
1GbE ports 1-12
100/1GbE ports C1- C2
100/1GbE SFP ports F1-F2
1GbE RJ45 ports
An ICX t6430-C device provides 12 RJ45 ports that reside on Slot 1 of the device. The 12 RJ45 ports
operate at 10 Mbps or 100 Mbps half or full duplex, or at 1000 Mbps full duplex. Because all ports
support automatic MDI or MDI-X operation, you can use straight-through cables for all network
connections to PCs or servers, or to other devices or hubs. In addition, it is ideal (and preferred) to use
straight-through cables for switch-to-switch connections.
Each port supports auto-negotiation, so the optimum transmission mode (half or full duplex), and the
data rate (10, 100, or 1000 Mbps) can be selected automatically. If a device connected to one of these
ports does not support auto-negotiation, the communication mode of the port can be configured
manually.
100/1GbE uplink ports
An ICX 6430-C device provides 4 independent 100Mbps/1GbE uplink ports.
100/1GbE RJ45 ports C1 and C2, residing on slot 2 of the device, can be used as uplink ports or
additional network connections.
Additionally, an ICX 6430-C device contains two 100Mbps/1GbE small form factor pluggable (SFP)
ports (ports F1 and F2). These ports reside on slot 3 of the switch and can be used as uplink ports. In
future releases they can be used for stacking, though the stacking functionality is not available in
release 08.0.00. The SFP ports support 100Mbps/1GbE port speeds.
For information about supported SFP transceivers, refer to the following Brocade website:
Slot designations
Brocade ICX 6430-C Compact Switch Hardware Installation Guide
11
53-1003080-01