Brocade VDX 6730 Hardware Reference Manual (Supporting VDX 6730-32 and VDX 6730-76) - Manual (Page 58)

40 Brocade VDX 6730 Hardware Reference Manual
53-1002389-06
Replacing a combined FRU in a Brocade VDX 6730-32
5
Time and items required
Replacing a combined power supply and fan assembly in the switch should take less than two
minutes.
You need the following items to replace a power supply and fan assembly in a Brocade VDX
6730-32:
• A new power supply and fan assembly (must have the same part number and the same airflow
label as the power supply and fan assembly being replaced)
• A #1 Phillips screwdriver
Replacing the power supply and fan assembly
Complete the following steps to replace a combined power supply and fan assembly in a Brocade
VDX 6730-32.
1. Unplug the power cord from the combined power supply and fan assembly you are replacing.
2. Unscrew the captive screw on the power supply and fan assembly you are replacing using the
Phillips screwdriver.
3. Remove the power supply and fan assembly from the chassis by pulling the handle out and
away from the chassis.
CAUTION
The power supply switch must be in the off position when inserting it in the chassis.
4. Ensure that the new power supply and fan assembly has the same part number as the FRU
being replaced and then install the new FRU in the chassis:
Steady green Assembly is operating normally. No action required.
Blinking green One of the following may have occurred:
•
Mismatched airflow on power supply
and fan assembly
•
The power supply and fan assembly was
disabled by the user.
•
The power supply and fan assembly
power switch has been turned off or the
unit has been unplugged.
•
One or more of the fans in the fan
assembly has failed or the power supply
has failed.
Take one of the following actions:
•
Replace the power supply and fan
assembly with one that has the
correct airflow direction.
•
Verify that the power supply and fan
assembly is enabled.
•
Check the power switch and plug.
•
Replace the power supply and fan
assembly.
TABLE 6 Brocade VDX 6730-32 LED behavior, descriptions, and required actions
LED color and behavior Description Action required