Avaya P880 - Manual (Page 41)

A-7 610-0184-095 June 14, 2001
Setting WFQ
Overview
Setting the weighted fair queuing (WFQ) service policy involves two
commands. In the first command, you specify the queue policy, the
modules and ports for which you want to set the policy, and
whether you want to set the queue service policy for ingress traffic,
egress traffic, or both. In the second command, you specify the
queue weights.
Command 1
The correct syntax for Command 1 is:
> (configure)# set queue-service {|
swport-range>}[...,{|}] wfq
egress
where:
is the slot number.
is a slot and port range in the form of 3/1
or 3/1-5 . If you specify this parameter, then only the ports
on the module in slot are set.
egress is the direction of traffic for which the policy is set.