Avaya P880 - Manual (Page 26)

610-0184-095 26 June 14, 2001
Problem: If you remove the Public community string from the SNMP
Community Management, save the running config to the startup
config and then reset the switch, the Public community string you
removed is not deleted.
Workaround: Change the Public Community string to a different name.
P580/P882 Chassis Slot 2
The following problem has no workaround:
■
Cajun P580/P882 switches running in Fabric 2 mode will not
route inbound multicast traffic received by an unlicensed 80-
Series module when installed in slot 2.
Downloading the Startup Configuration File
Problem: Downloading the startup configuration file produces panic messages
in the CLI of the supervisor module and ATM Uplink module.
Workaround: Ignore these messages.
Supervisor Module
80-Series
Supervisor
Module
The following problem has no workaround:
■
To successfully synchronize two 80-Series Supervisor
modules (M8000R-SUP), both modules must be in 48-port
mode and in the same fabric mode.
Problem: Panic messages display on the CLI and on the Primary Supervisor
LED readout after you install a second Supervisor module for
redundancy.
Workaround: Ignore these messages.