Avaya P880 - Manual (Page 27)

27 610-0184-095 June 14, 2001
Problem: When the 80-series Supervisor module boots, the switch displays
the following error message in the CLI:
Undefined Error -- FILE:gqswport.cLINE:449 Value
0xfffffffc: Error changing the GQ ‘port use
diffserv’ flag
Workaround: Ignore this message.
50-Series
Supervisor
Module
The following problem has no workaround:
■
The display on the P880 switch M5500R-SUPA supervisor
module may not initialize properly. However, if it becomes
the active supervisor module, the display becomes functional
and displays the proper information.
Switch Ports
The following problem has no workaround:
■
While switch port parameters are reflected across all ports of
a Hunt group, spanning tree parameters are not. If you
change the spanning tree priority of the flood port of a Hunt
group, but that port does not come up first when bringing up
the Hunt group, the spanning tree priority for the group
reverts to the default.
Problem: If a switch port is moved from Bind to Receive to Static, all
previously bound VLANs are not removed.
* Note: This is NOT a problem with the Bind to All setting.
Workaround: Remove VLANs manually from a port when changing a switch port
connection from Bind to Receive to Static.
RIP
Problem: Configuring a RIP V1/V2 interface sends V2 packets to a V1
interface.
Workaround: If the corresponding interface is in RIP v1, configure your interface
to RIP v1.