Avaya P880 - Manual (Page 10)

610-0184-095 10 June 14, 2001
* Note: Avaya recommends that you mirror traffic to a port
of the same speed or faster than the source port.
■
is the mirror channel that you want to use (1-4).
■ {TX| RX |Both} is the direction of traffic that you want to
mirror.
* Note: You can mirror transmit traffic of only one source
port to the mirror port. You cannot mirror transmit
traffic of multiple source ports to one mirror port.
■
{always | disable | periodic} is how often you
want the mirror port to receive traffic samples.
■
is the maximum number of
packets per second that you want the mirror port to receive.
(Enter a value for this variable only if you set the sampling to
periodic.)
Removing Port
Mirroring
To remove port mirroring, use the following CLI command:
>(config)# clear port mirror fabric_mode2
channel
where is the mirror channel that you want to remove.
Viewing
Information
about Port
Mirroring
To view information about port mirroring, use the following CLI
command:
>(config)# show port mirror fabric_mode2
This command displays the source ports, mirror port, direction being
mirrored, sampler type, and maximum packet per second for all port
mirrors that are currently set up.