5 setting of auto-calibration component – Yokogawa IR200 User Manual
Page 45
6 - 10
IM 11G02M01-01E
1. During measurement, press the
MODE
key
to display the User mode.
2. Point the cursor to “Setting about Cali-
bration” by pressing the
or
key.
Press the
ENT
key.
3. In the “Setting about Calibration” screen
that appears, point the cursor to “Auto
Calibration Components” by pressing the
or
key. Press the
ENT
key.
4. In the “Auto Calibration Components”
selection screen that appears, point the
cursor to the CH you want to set by
pressing the
or
key. Press the
ENT
key.
(
)
ENT
(
)
ENT
MODE
(
)
ENT
6.2.5 Setting of auto-calibration component
It sets the CH (component) to be calibrated in the auto-calibration.