Selecting a printer stand, Activating the bottom-feed tractors, Path: bottom – AMT Datasouth ACCEL-6300 User Manual
Page 153
User's Guide
A-2 Bottom-Feed Tractors
Selecting a Printer Stand
You'll need a sturdy printer stand with a paper slot through which paper
can be fed. The paper slot permits pin-feed paper to feed straight up
from below the printer to the bottom-feed tractors. When selecting a
printer stand, observe the following guidelines:
9
9
9
9
9 The stand must be sturdy enough to support the weight of the printer:
54 pounds (24.5 kg) for wide-carriage models or 48 pounds (21.8 kg)
for narrow-carriage models.
9
9
9
9
9 The table top must be wide enough to hold the printer: 24 inches
(61 cm) for wide-carriage models or 19 inches (48.3 cm) for nar-
row- carriage models. It must also be at least 17 inches (43.2 cm)
deep.
9
9
9
9
9 The paper slot must be wide enough for the paper you intend to use
and at least 1.5 inches (3.8 cm) deep.
9
9
9
9
9 The stand should contain shelves or bins for paper entering and
exiting the printer.
Activating the Bottom-Feed Tractors
To activate the bottom-feed tractors so that they will feed paper, press
the Paper Path button on the control panel as needed to select the Bottom
paper path.
Figure A-2. Selecting the Bottom Path
PATH:
Bottom
Paper
Path
User's Guide
A-2 Bottom-Feed Tractors
Selecting a Printer Stand
You'll need a sturdy printer stand with a paper slot through which paper
can be fed. The paper slot permits pin-feed paper to feed straight up
from below the printer to the bottom-feed tractors. When selecting a
printer stand, observe the following guidelines:
9
9
9
9
9 The stand must be sturdy enough to support the weight of the printer:
54 pounds (24.5 kg) for wide-carriage models or 48 pounds (21.8 kg)
for narrow-carriage models.
9
9
9
9
9 The table top must be wide enough to hold the printer: 24 inches
(61 cm) for wide-carriage models or 19 inches (48.3 cm) for nar-
row- carriage models. It must also be at least 17 inches (43.2 cm)
deep.
9
9
9
9
9 The paper slot must be wide enough for the paper you intend to use
and at least 1.5 inches (3.8 cm) deep.
9
9
9
9
9 The stand should contain shelves or bins for paper entering and
exiting the printer.
Activating the Bottom-Feed Tractors
To activate the bottom-feed tractors so that they will feed paper, press
the Paper Path button on the control panel as needed to select the Bottom
paper path.
Figure A-2. Selecting the Bottom Path
PATH:
Bottom
Paper
Path