ATTO Technology FastStream SC 5700 - Manual (Page 62)

xv
ATTO Technology Inc. FastStream SC Installation and Operation Manual
RMStatus
Displays the status of all RAID members within the specified
RAID group or a particular RAID member if specified within the
specified RAID group.
RMStatus [GroupName]
Route
SC 5300
Assigns a host protocol address to a target destination device.
More than one FC LUN may be assigned to a partition. If you try
to map a new partition to the same FC LUN, the previous map
is overwritten. Use the delete identifier to remove the map. In
verbose mode, overwriting a map requires secondary
confirmation of the action.
If FCMultiNode is disabled: Route FC [lun] [RAID
[GroupName] [PartIndex]] | Delete]
If FCMultiNode is enabled: Route FC [fp] [lun] [RAID
[GroupName] [PartIndex]] | Bridge | Delete]
Route
SC 5500
Assigns a host protocol address to a target destination device.
More than one FC LUN may be assigned to a partition. If you try
to map a new partition to the same FC LUN, the previous map
is overwritten. Use the delete identifier to remove the map. In
verbose mode, overwriting a map requires secondary
confirmation of the action.
You may also map pass through devices.
If
FCMultiNode is disabled: Route FC [lun] [RAID
[GroupName] [PartIndex]] |SAS [SASIndex] ] |
Delete]
If FCMultiNode is enabled: Route FC [fl] [lun] [RAID
[GroupName] [PartIndex]] |SAS [SASIndex] ] |
Delete]
Route
SC 5700
Assigns a host protocol address to a target destination device.
More than one FC LUN may be assigned to a partition. If you try
to map a new partition to the same FC LUN, the previous map
is overwritten. Use the delete identifier to remove the map. In
verbose mode, overwriting a map requires secondary
confirmation of the action.
You may also map pass through devices.
If
FCMultiNode is disabled: Route FC [fl] [RAID
[GroupName] [PartIndex]] |FC [fp] [Index]] | Delete]
If FCMultiNode is enabled: Route FC [fp] [fl] [[RAID
[GroupName] [PartIndex]] |FC [fp] [Index]] | Delete]
RouteDisplay
Displays a combined list of host protocol address to target
destination device mappings.
If FCMultiNode is disabled: RouteDisplay [FC] |
passthrough | persistent>
If FCMultiNode is enabled: RouteDisplay [FC] <
> | passthrough | persistent>
SASTargets
SC 5500
Lists the physical devices that are connected to all SAS ports.
SASTargets
SaveConfiguration
Issued with the restart option, cycles unit power after saving
configuration changes. The norestart option saves changes
without restarting.
Note
Certain modifications require a system restart.
SaveConfiguration
SCSIDomainValidation
SC 5300
Runs Domain Validation tests on the SCSI system which may
detect problems with SCSI cables, termination or damaged
transceivers. Tape drives attached to the FastStream should be
loaded with media. The media is not overwritten.
SCSIDomainValidation
SCSIInitID
SC 5300
Specifies the persistent SCSI initiator ID used by the unit on this
SCSI bus. All maps coinciding with the user-specified ID are
destroyed after this command is issued.
Default: 07
set SCSIInitID [sb] [0-15]
get SCSIInitID [sb]
SCSIPortBusSpeed
SC 5300
Controls the transfer rate at which the unit attempts to negotiate
with its SCSI devices.
Default: ultra320
set SCSIPortBusSpeed [sb] [fast | ultra | ultra2 | ultra160
| ultra320]
get SCSIPortBusSpeed [sb]