ATTO Technology 2500C User Manual
Atto, Ipbridge, 2500c/r/d
ATTO Technology, Inc.
ATTO
iPBridge
TM
2500C/R/D
Installation and Operation Manual
© 2005 ATTO Technology, Inc. All rights reserved. All brand or product names are trademarks of their
respective holders. No part of this manual may be reproduced in any form or by any means without the
express written permission of ATTO Technology, Inc.
8/2005 Document Control Number: PRMA-0335-000
Table of contents
Document Outline
- 1 iPBridge 2500 provide storage options
- 1.1 ATTO iPBridge 2500R/D
- 1.2 ATTO iPBridge 2500C
- 2 Configuring the iPBridge
- 2.1 Getting an IP address
- 2.2 NDMP configuration provides backup
- 2.3 Mapping devices: NDMP
- 2.4 Mapping devices: iSCSI
- 2.5 Additional configurations
- 3 ATTO ExpressNAV interface
- 3.1 ExpressNAV pages
- 4 Updating firmware
- 5 Copying iPBridge configurations
- 6 Troubleshooting
- Inside out method
- Check the host event log
- Check the iPBridge event and trace logs
- Visually inspect LEDs
- Check for problems on attached devices
- Check host versions
- Check iPBridge product versions
- Component check
- Checking SCSI devices
- Checking the iPBridge SCSI ports
- Checking the serial port
- Checking the iPBridge internal configuration
- Checking iPBridge Ethernet ports
- Checking the LAN/WAN
- Checking the iSCSI Host Adapter or NIC
- Checking the iSCSI OS driver
- Checking the Operating System
- Checking the applications
- Performance issues
- Checking SCSI devices
- Checking iPBridge SCSI ports
- Checking iPBridge Ethernet ports
- Checking the LAN/WAN
- Checking Ethernet Host Adapter or NIC
- Checking the applications
- Checking the host system
- Checking the Operating System
- 7 Alternative interface options
- 7.1 CLI provides ASCII-based interface
- 7.1.1 CLI commands summary
- 7.1.2 General use commands
- 7.1.3 Maintenance commands
- 7.1.4 Diagnostic commands
- BridgeModel
- BridgeName
- ClearEventLog
- ClearTraceLog
- DisplayEventLog
- DisplayEventLogFilter
- DisplayTraceLog
- DisplayTraceLogFilter
- DumpEventLog
- DumpTraceLog
- EventLog
- EventLogFilter
- Help
- IdentifyBridge
- Info
- iSCSITargetNameDisplay
- IsReserved
- NDMPStatus
- Ping
- RMON
- RouteDisplay
- SCSIPortList
- SCSITargets
- SerialNumber
- SNMPDumpMIB
- SNMPExtendedTraps
- SNMPTrapAddress
- SNMPTraps
- TailEventLog
- Temperature
- TraceLog
- TraceLogFilter
- Voltage
- WrapEventLog
- WrapTraceLog
- 7.1.5 SCSI configuration commands
- 7.1.6 Serial port configuration commands
- 7.1.7 Ethernet commands
- 7.1.8 NDMP commands
- 7.1.9 iSCSI commands
- 7.1.10 Mapping commands
- Appendix A ATTO iPBridge, FibreBridge family
- Appendix B Cabling
- Appendix C Glossary
- Appendix D Safety standards and compliances
- Appendix E ATTO accessories
- Appendix F Warranty, contact information