ATTO Technology FC-44ES User Manual
ATTO Technology Hardware
ATTO Celerity Fibre Channel Host Adapters
Installation and Operation Manual
Celerity FC-84EN
8Gb FC quad channel PCIe 2.0 host adapter
Celerity FC-82EN
8Gb FC dual channel PCIe 2.0 host adapter
Celerity FC-81EN
8Gb FC single channel PCIe 2.0 host adapter
Celerity FC-44ES
4Gb FC quad channel PCIe host adapter
Celerity FC-42ES
4Gb FC dual channel PCIe host adapter
Celerity FC-41ES
4Gb FC single channel PCIe host adapter
Celerity FC-41XS
4Gb FC single channel PCI-X host adapter
This manual is related to the following products:
Table of contents
Document Outline
- 1 ATTO Celerity HBA Features & Overview
- 2 Install Drivers
- Windows
- OS X
- Driver Installation (for all ATTO FC host adapters)
- Installing a fresh copy of OS X onto a disk attached to a Celerity FC adapter (only for 8Gb FC adapters)
- Adjusting adapter settings with the EFI Configuration Utility (only for 8Gb FC adapters)
- Installing OS X Lion or Snow Leopard onto a disk attached to a Celerity adapter (only for 8Gb FC adapters)
- Installing OS X Leopard or Tiger onto a disk attached to a Celerity adapter (only for 8Gb FC adapters)
- Linux
- VMware ESXi 5
- VMware ESX/ESXi 4
- VMware ESX 3.5
- NPIV Support
- Specialized configurations
- 3 Hardware Installation
- System requirements
- Fibre Channel address
- Installation
- Bracket details
- Exhibit 3-1 FC-84EN
- Exhibit 3-2 FC-82EN full height and low profile
- Exhibit 3-3
- Exhibit 3-4 FC-81EN full height and low profile
- Exhibit 3-5 FC-44ES full height
- Exhibit 3-6 FC-42ES low profile, full height
- Exhibit 3-7 FC-41ES low profile and full height
- Exhibit 3-8 FC-41EL low profile, full height
- Exhibit 3-9 FC-41XS low profile and full height
- Adapter board details
- 4 Updating Hardware Flash, Drivers
- 5 Troubleshooting
- General suggestions
- Mac OS X
- Windows Server 2008, 2003, 2000; Vista, XP
- Linux
- VMware
- Supplemental Guide for VMware ESX/ESXi
- 1 Driver Configuration
- 2 Adapter Management
- 2.1 vSphere Client
- 2.2 Service Console
- 3 Virtual Ports (NPIV)
- Information about the VPorts is shown in the Driver Info file on the Service Console.
- For additional NPIV Configuration details, please consult the VMware Fibre channel SAN Configuration Guide (http://www.vmware.com/pdf/vsphere4/r41/vsp_41_san_cfg.pdf).
- Appendix A Glossary
- Appendix B Accessories
- Appendix C ATTO Adapter Selection Guides
- Appendix D Standards, Compliances: 8Gb adapters
- Appendix E Standards, Compliances: 4Gb adapters
- Appendix F Safety, Warranty