Assembly of power divider, Assembly of power divider -24, Maintenance – Alamo Flex-Wing Mechanical Level Lift Rotary Cutter/Shredder EAGLE 10/15 User Manual

Page 168

MAINTENANCE

EAGLE 15 03/09

Maintenance Section 5-24

MAINTENANCE

Assembly of Power Divider

STEP 1

Install the Bearing Race into the Hub cap.

STEP 2

Install the Bearing on the Output Shaft. FIGURE Mnt-R-0054. Place the Shaft into the Hub Cap. FIGURE Mnt-

R-0055. Place the Bearing (FIGURE Mnt-R-0056) on the Shaft and drive it down. Place the Gear (FIGURE

Mnt-R-0057) on the Shaft.

STEP 3

Apply some Locktite on the Adjusting Nut (FIGURE Mnt-R-0059). Install the Adjusting Nut onto the Shaft.

Tighten the Nut until it is difficult to turn the Shaft. FIGURE Mnt-R-0060. Check to be sure that the Retaining

Ring is fully engaged in the counter bore. While holding Hub, tap each end of Shaft and check to see if it has