IEI Integration ECW-281B_B2-D525 - Manual (Page 83)

ECW-281B/B2-D525 Embedded System
Page 70
5.4.1 Host Bridge
Use the Host Bridge menu (
6
BIOS Menu 13 ) to configure the host bridge chipset.
Aptio Setup Utility – Copyright (C) 2010 American Megatrends, Inc.
Chipset
> OnChip VGA Configuration
Initiate Graphic Adapter
[IGD]
******* Memory Information ********
Memory Frequency
800 Mhz
Total Memory
2048 MB
DIMM#0 2048
MB
DIMM#1 Not present
Config On Chip VGA
Settings
---------------------
ÅÆ: Select Screen
↑ ↓: Select Item
Enter
Select
F1 General Help
F2 Previous Values
F3 Optimized
Defaults
F4 Save
ESC Exit
Version 2.02.1205. Copyright (C) 2010 American Megatrends, Inc.
BIOS Menu 13:Host Bridge Configuration
Î Initiate Graphic Adapter
Use the Initiate Graphic Adapter option to select the graphics controller used as the
primary boot device. Select either an integrated graphics controller (IGD) or a combination
of PCI graphics controller, a PCI express (PEG) controller or an IGD. Configuration
options are listed below:
ƒ IGD
ƒ PCI/IGD D EFAULT