Figure 4-10: hdd thermal pad – IEI Integration ECW-281B_B2-D525 User Manual

Page 54

ECW-281B/B2-D525 Embedded System

Page 41

Figure 4-10: HDD Thermal Pad

Step 8:

Replace the HDD bracket onto the bottom surface by aligning the four retention

screw holes in the HDD bracket with those in the back of the bottom surface.

Step 9:

Reinsert the four previously removed retention screws.

Step 10:

Connect the SATA cable connector in the ECW-281B/B2-D525 to the HDD.

Step 11:

Replace the bottom surface to the bottom panel by reinserting the six previously

removed retention screws.

Step 0:

WARNING:

Over-tightening bottom cover screws will cause damage to the bottom

surface. Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).