IEI Integration ECW-281B_B2-D525 - Manual (Page 45)

ECW-281B/B2-D525 Embedded System
Page 32
1 Driver and manual CD
1
Wireless antenna (wireless model only)
1 Power cord
(optional for WD models)
1 Power adapter with ERP and PSE
certificates (optional for WD models)
(P/N: 63000-FSP060DBAB1552-RS)
1 VESA MIS-D 100 wall mount kit
(optional)
Table 4-1: Package List Contents
4.2.3 Bottom Surface Removal
WARNING:
Over-tightening bottom cover screws will cause damage to the bottom
surface. Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
Before the jumper settings can be configured and the hard disk drive can be installed, the
bottom surface must be removed. To remove the bottom surface, please follow the steps
below:
Step 1: Remove the bottom surface retention screws. The bottom surface is secured to
the chassis with six retention screws (
765
Figure 4-1 ). All six screws must be
removed.