IEI Integration NANO-HM651 - Manual (Page 70)

NANO-HM651 EPIC SBC
Page 56
Step 3: Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the NANO-HM651, connect the cable connectors to
the on-board connectors. See Figure 4-15.
Figure 4-15: Dual USB Cable Connection
Step 4: Attach the USB connectors to the chassis. The USB 2.0 connectors each of
two retention screw holes. To secure the connectors to the chassis please refer
to the installation instructions that came with the chassis. Step 0:
4.9 External Peripheral Interface Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
ƒ RJ-45 Ethernet cable connectors
ƒ USB devices
ƒ VGA monitors
ƒ HDMI displays
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding NANO-HM651 external peripheral interface connector making
sure the pins are properly aligned.